FMF

US-400S Ultrasonic Web Guide Sensor for EPC Edge Detection

$70.73 USD

~~$0.00 USD~~ $70.73 USD

Sale Sold out

Taxes included. Shipping calculated at checkout.

US-400S slot-type ultrasonic web guide sensor

The US-400S is a slot-type ultrasonic sensor for EPC web guiding systems. It uses ultrasonic through-beam detection to identify the edge position of roll-fed materials and send correction signals to the web guide controller.

Key details

Model	US-400S
Sensor type	Slot-type ultrasonic web guide sensor
Tracking method	Opposite-edge tracking
Use	Edge detection for EPC web guiding systems
Power input	DC12V
Output signal	0-5V analog output and dual-channel NPN switching output
Detection range	6 mm, +/-3.0 mm
Detection accuracy	+/-0.05 mm
Detection method	200K ultrasonic through-beam opposed detection
Wiring reference	Brown +12V, blue GND, white 0-5VDC, black NPN1, gray NPN2
SKU reference	FMF-US-400S-43641

Material fit

Suitable for airtight roll materials such as transparent film and paper.
Not suitable for breathable materials such as canvas or non-woven fabric.
Useful when photoelectric sensors are affected by transparent material behavior.
No routine manual calibration adjustment is required during normal use after setup.

Operating notes

The sensor supports one analog output and two switching outputs.
Three status options are available for different accuracy requirements: 0.5 mm, 1.0 mm, and 2.0 mm.
Use the SET key to select the required status, then save the setting after calibration.

FAQ

What is the US-400S used for?

It detects the material edge position in an EPC web guiding system so the controller can correct web alignment.

Why use an ultrasonic edge sensor instead of a photoelectric sensor?

For transparent airtight materials, ultrasonic edge detection is less affected by material transparency than a photoelectric sensor.

Can it be used with non-woven fabric?

No. breathable materials such as canvas and non-woven fabric are not applicable.

What should I confirm before ordering?

Confirm that your controller accepts DC12V power, 0-5V analog output, and the listed NPN switching outputs, and check the sensor mounting position against your current web guide system.

US-400S ultrasonic web guide sensor outline dimensions