FMF Supply
Dental Sealing Machine SEAL Autoclave Sterilization Equipment | Beep Alert Heat Sealer for Dentist Clinic Tools
Dental Sealing Machine SEAL Autoclave Sterilization Equipment | Beep Alert Heat Sealer for Dentist Clinic Tools
Regular price
$418.75 USD
Regular price
$0.00 USD
Sale price
$418.75 USD
Taxes included.
Shipping calculated at checkout.
Quantity
Couldn't load pickup availability
Dental Sealing Machine SEAL Autoclave Sterilization Beep-alert Dentist Equipment
Sella II is intended for sealing envelopes for steam sterilization, one of sterilization auxiliary series products, which is attractive, stable, easy operation and low maintenance rate. Terrific transformer will automatically adjust to the best sealing temperature even in unstable voltage.
Nice aluminum alloy body, easy for clean, and come with integrated cutter with 100,000 times cutting guarantee.
Technical parameters
Sella II |
|||
Power input |
AC 110/220 V 50/60 Hz |
Pre-heating time |
2 – 3 minutes |
Power output |
100 W |
Heat preservation |
Yes |
Seal width |
12 mm |
Dimensions (W*L*H) |
46*36*17 CM |
Seal length |
30 cm |
Gross weight |
8 KG |
Specifications
1) Beep-alert (for heating Status);
2) Energy saving design;
3) Comes with integrated cutting and roll support;
Sella II is intended for sealing envelopes for steam sterilization. Follow strictly the instructions and orientations from the manufacturer of your packages regarding their appropriate usage, cautions, conservation and storage.
WARNING! Since the sealer works at high temperatures, be careful not to accidentally touch its hot areas. The blades are very sharp and, in order to avoid accidents, caution is required when handling them.
Instruction
Connect the power cord to the power connector which is on the back side of the sealer, check if the voltage of your equipment matches the voltage of the local electrical network.
Switch the sealer on by using the power switch on its back side and adjust the sealing temperature through the temperature selector on its right side according to the thickness of the material to be sealed. When the green LED goes off (after around 2 minutes) the sealer will be ready to be used.
Place the roll on the holder. The beginning of the roll shall be inserted through the back side, between the pressure bar and the sealing bar always with the paper side down (resistance’s side) and the plastic side up (directly under the upper pressure bar). Pull the sealer arm towards the operator and press it down softly until it is locked. Exaggerated pressure may break the sealer arm and this kind of damage is not covered by the warranty. The sealing time (around 4 seconds) must be manually controlled by the user.Note: If the sealing temperature is too low or too high the sealing might be inefficient (the envelopes may be stuck to the sealing area when they are pulled or be visibly badly-sealed). To correct this, adjust the timer properly. Once adjusted it is not necessary to perform any other adjustment to continue sealing.
To cut the packages, still with the arm locked, slide the blade from one side to the other, raise the sealer arm and remove the envelopes. Note: If the blade knob is pulled slowly the paper may crease and the cutting will not be adequate. To make it more precise, pull the blade knob quickly. If necessary, slide the cutting blade more than once.
